Back to "Series Circuits" Chapter 3 


Series Circuit JAVA Troubleshooting Simulation #  2
   To Simulation #1 and Simulation MENU

In the circuit below use the "No Fault" condition as a base line to determine which resistor has failed or changed value in each faulty circuit( Fault 1 thru Fault 4.) Then check your result by clicking "Answer" at bottom of page and compare resistor values with those given with schematic.

       Vs = 12.0 Vdc   Rs = 0.60 ohm
      R1 = 22, R2 = 3.3,  R3 = .5, R4 = 50.0 ohm

DC Voltmeter Volts

No Fault
Fault 1
Fault 2
Fault 3
Fault 4